請教一下，T2000的ALOM密碼忘記，有沒辦法重置？

ericyan_cu

如題，我這個是富士通T2000.

狂日一條

能進系統的話可以這樣：
# cd /usr/platform
# ls       #查看支持的型號，找出自己的機器型號#
# cd SUNW,XXXX #選擇你的機器型號#
# cd sbin
# ./scadm help    #使用幫助命令查看scadm可以執行的命令和作用#
scadm usershow [username] => show user details
scadm userpassword <username> => set user password

如果不能進系統，有一個短接法什么來著，好像handbook上能找到，你網上搜搜。。

東方蜘蛛

How to reset the ALOM password on a Sun Fire[TM] T1000 or T2000 server

Note: physical access to the system so that the power cables can be accessed and a serial connection can be made to the system is required for this procedure.
1. Make a connection to the ALOM serial management port.

2. Power cycle the system by unplugging the server's power supplies, waiting several seconds and then plugging the power supplies back in.

3. You should see the ALOM booting on the serial management console. Hit "Esc" (the Escape key) during the ALOM boot, before or at the point: "Return to Boot Monitor for Handshake"

This will cause the system to produce the message: "Return to Boot Monitor for Handshake ESC keypress detected."

4. ALOM will now enter the "ALOM boot escape menu" and the following will be displayed:

ALOM <ESC> Menu

e - Erase ALOM NVRAM.
m - Run POST Menu.
R - Reset ALOM.
r - Return to bootmon.
Your selection:

5. To clear out the existing password you must choose 'e' to erase the ALOM NVRAM. After using the 'e' option to erase the NVRAM choose the 'r' option to resume the ALOM boot. You will automatically be logged in as user 'admin' with no password and no permissions. The NVRAM settings will be reset to their factory defaults. Note that since this procedure resets the NVRAM settings to their defaults any customization (such as the ALOM network settings) will need to be recreated.

The above procedure can be adapted for the two Blade products Sun Blade T6300
Server Module and Netra CP3060 Board, which also use the ALOM4v.

1. Ensure a working serial connection is made to the serial port at the front of the Blade.

2. Power cycle the board by powering off the server as per the relevant
architecture, unplug the Blade from the chassis, wait several seconds and then
plug the Blade back into the chassis.

Follow steps 3 to 5 above.

富士通的就不知道能不能用這個方法了

財版

翻翻蜘蛛的精華帖

ericyan_cu

回復 3# 東方蜘蛛


    試過，按ESC鍵沒動靜。。。。

goldfishway

蜘蛛正解

goldfishway

富士通的 T2000 就是面板是灰色的 其余都是跟sun的一樣