SW_MATM-4-MACFLAP_NOTIF 這種故障如何解決？

CU168007041

在備用的3750上顯示以下信息
[OK]
C-3750#s log
Syslog logging: enabled (0 messages dropped, 0 messa ...
qdigrp 發表于 2011-01-05 12:27

從vlan 7 , vlan 44 , vlan11 上看，狀態穩定不下來。我曾經提醒你說，只在做主響應的路由器4506上使用preempt參數，你最初給的配置清單顯示，在3750上你也用了該參數。造成他們爭奪active身份。

ssffzz1

從vlan 7 , vlan 44 , vlan11 上看，狀態穩定不下來。我曾經提醒你說，只在做主響應的路由器4506上使用 ...
CU168007041 發表于 2011-01-06 20:29

    應該不會。從規程上來看。優先級相同則比較MAC。

qdigrp

回復 89# ssffzz1

1、你確信是銷售大廳的2960接入后就有問題?:
   是的我可以確定，因?yàn)槲椰F(xiàn)在的網絡就是將（立體庫、主廠房、輔助樓）三個地方接入層的設備分別接入45 和37的，而我一但將銷售大廳接入的就出問題。
  另外我將其他三個地方接入層設備撥掉時,只接銷售大廳，也出現問題。
2、把2960下接PC的線都拔掉，直接2條線分別接45和37也出現問題。
  我沒有做的這么徹底，（就是沒有撥線），我只做了用一臺接入設備去連45和37
3、把2960換掉也出問題。
   是的，我用另外一臺2960單臺接入也是出現問題，只不過這臺設備也是從銷售大廳原有的設備.
不確定的問題：
2960和45/37間是一條鏈路還是做了鏈路聚合。這些鏈路是光纖還是電接口。
是一條鏈路，中間的物理線是光纖（單模），通過光纖收發器轉成電口的，再接到2960上的
其他三幢樓也是同樣的道理 。

qdigrp

回復 91# CU168007041


    您好，你怎么就確定就只有 vlan 7 44 11這三個不穩定，其他的確都穩定。
從3750 log 上看，所有的vlan都有從speak--->active的過程,都沒有規律的

另外一個細節就是我在另外一個局域網完全安照些配置方法去做，一點問題都沒有。

qdigrp

我現在，在想是或需要，將備用的3750給更換掉的，換另外一臺3750來做standby

CU168007041

回復 94# qdigrp

好像不僅這3個vlan，我只追蹤了這3個，發現他們在短時間內不停轉換身份，故推測可能是45和37上都使用了preempt參數導致的。因?yàn)檎�常配制的話，不是都使用這個參數的。
正常情況應該是speak ---> active后，不會在短時間內頻繁切換呀。某些vlan好像就穩定在active狀態。

CU168007041

回復 92# ssffzz1
從他貼出的配置看，優先級是不同的。但兩邊都使用preempt，我覺得不應該，按道理來說，只能定義一個為主，另一個為輔。不能讓兩個都競爭主。就如同公司有一個正總裁，一個副總裁，當正總裁不在的時候，副總裁可以代替總裁行使總裁職權，當正總裁回來的時候，副總裁就要交回權利，不能握著權利不放。

qdigrp

你可能說的有道理，因?yàn)槲以缟弦寻褌溆玫?750做cold restart  處理，然后在網絡正常用的情況下得到的以下log：

00:01:28: %STACKMGR-6-MASTER_READY: Master Switch 1 is READY
00:01:30: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/1, changed state to up
00:01:30: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/13, changed state to up
00:01:30: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/14, changed state to up
00:01:33: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/4, changed state to up
00:01:34: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/2, changed state to up
00:01:34: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/1, changed state to up
00:01:34: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/14, changed state to up
00:01:34: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/13, changed state to up
00:01:35: %LINK-3-UPDOWN: Interface Port-channel1, changed state to up
00:01:35: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/4, changed state to up
00:01:36: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/2, changed state to up
00:01:36: %LINEPROTO-5-UPDOWN: Line protocol on Interface Port-channel1, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan7, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan10, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan11, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan13, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan15, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan16, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan17, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan18, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan21, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan23, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan40, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan41, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan43, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan44, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan45, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan46, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan47, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan60, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan61, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan62, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan81, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan90, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan91, changed state to up
00:02:04: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan100, changed state to up
C-3750#

qdigrp

那按照您的意思 我應該如何處理，是不是在備用的3750上去掉preempt參數???

qdigrp

可為什么其他三幢樓的接入層，接入，就沒有任何問題.